Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20103 L4-2.5LREPAIR AND DIAGNOSISBODY AND FRAMELOCKSKEYLESS ENTRYKEYLESS ENTRY RECEIVERSERVICE AND REPAIR
2010 Mazda 3 L4-2.5L
Keyless Entry Receiver: Service and Repair
2010 Mazda 3 L4-2.5LSECTION Service and Repair
KEYLESS RECEIVER REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the following parts:
a. Front scuff plate (LH) Front Scuff Plate Removal/Installation
b. Front side trim (LH) Front Side Trim Removal/Installation
c. Upper panel Upper Panel Removal/Installation
d. Shift knob (MTX) Service and Repair
e. Selector lever knob (ATX) Automatic Transaxle Shift Mechanism Removal/Installation
f. Shift panel Shift Panel Removal/Installation
g. Side wall Side Wall Removal/Installation
h. Console Console Removal/Installation
3. Set the hood release lever out of the way. Service and Repair
4. Remove the lower panel. (driver-side) Lower Panel Removal/Installation
5. Remove in the order indicated in the table.
6. Install in the reverse order of removal.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.