Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA2009TRIBUTE 4WD L4-2.5LREPAIR AND DIAGNOSISSTARTING AND CHARGINGSTARTING SYSTEMIGNITION LOCKSERVICE AND REPAIR
2009 Mazda Tribute 4WD L4-2.5L
Ignition Lock: Service and Repair
2009 Mazda Tribute 4WD L4-2.5LSECTION Service and Repair
IGNITION LOCK CYLINDER REMOVAL/INSTALLATION
NOTE:For non-functional ignition lock cylinders, the steering column lock module has to be replaced. See Service and Repair.
1. Remove the passive anti-theft system (PATS) transceiver. See Removal and Replacement.
2. Using a suitable tool, press the release pin and remove the ignition lock cylinder.
NOTE:The ignition lock cylinder must be in the RUN position.
3. To install, reverse the removal procedure.
- Verify the ignition lock cylinder operation.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.