Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Mazda RX8 2RTR-1.3LFACTORY OEM SERVICE PROCEDURE
PID/DATA Monitor Table
PCM INSPECTION [13B-MSP]
PID/DATA monitor table (reference)
PID/Data Monitor Table (Reference) (Part 1):
PID/Data Monitor Table (Reference) (Part 2):
PID/Data Monitor Table (Reference) (Part 3):
PID/Data Monitor Table (Reference) (Part 4):
PID/Data Monitor Table (Reference) (Part 5):
PID/Data Monitor Table (Reference) (Part 6):
PID/Data Monitor Table (Reference) (Part 7):
PID/Data Monitor Table (Reference) (Part 8):
PID/Data Monitor Table (Reference) (Part 9):
*1
Calculated value; differs from terminal voltage
*2
Refrigerant pressure switch (middle) turns off when the refrigerant pressure is 1.11 MPa {11.3 kgf/cm2, 161 psi} or less
*3
Refrigerant pressure switch (middle) turns on when the refrigerant pressure is 1.60 MPa {16.3 kgf/cm2, 232 psi} or more
*4
MT
*5
California emission regulation applicable model
*6
13B-MSP(high power)
*7
With VFAD
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.