Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Mazda RX8 2RTR-1.3LFACTORY OEM SERVICE PROCEDURE
Keyless Control Module Removal/Installation
KEYLESS CONTROL MODULE REMOVAL/INSTALLATION
1. When replacing the keyless control module, perform the following procedure:
- Keyless Control Module Configuration
Keyless Control Module Configuration
- Immobilizer System-related Parts Programming[with advanced keyless system]
(See. Advanced Keyless System)
- Immobilizer system-related parts programming[with keyless entry system]
Keyless Entry System
2. Disconnect the negative battery cable.
3. Remove the front side trim. Front Side Trim Removal/Installation
4. Remove the nut and screw.
5. Remove the connector clip installed to the bracket by shifting the keyless control module downward.
6. Disconnect the keyless control module connector.
7. Install in the reverse order of removal.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.