Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA2009CX-9 FWD V6-3.7LREPAIR AND DIAGNOSISWIPER AND WASHER SYSTEMSWIPER CONTROL MODULESERVICE AND REPAIR
2009 Mazda CX-9 FWD V6-3.7L
Wiper Control Module: Service and Repair
2009 Mazda CX-9 FWD V6-3.7LSECTION Service and Repair
AUTO LIGHT/WIPER CONTROL MODULE REMOVAL/INSTALLATION
NOTE:
- Auto wiper system are integrated with the auto light/wiper control module.
1. Disconnect the negative battery cable.
2. Remove the dashboard under cover (Driver side). Dashboard Under Cover Removal/Installation
3. Remove the auto light/wiper control module. Auto Light/Wiper Control Module Removal/Installation
4. Install in the reverse order of removal.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.