Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA2009CX-9 FWD V6-3.7LREPAIR AND DIAGNOSISWINDOWS AND GLASSWINDOWSPOWER WINDOW SWITCHSERVICE AND REPAIRPOWER WINDOW SUBSWITCH REMOVAL/INSTALLATION
2009 Mazda CX-9 FWD V6-3.7L
Power Window Subswitch Removal/Installation
2009 Mazda CX-9 FWD V6-3.7LSECTION Power Window Subswitch Removal/Installation
POWER WINDOW SUBSWITCH REMOVAL/INSTALLATION
Passenger Side
1. Disconnect the negative battery cable.
2. Remove the inner garnish. Inner Garnish Removal/Installation
3. Remove the front door trim. (See Front Door Trim Removal/Installation)
4. Remove the screw, and remove the power window subswitch from inside the front door trim.
5. Install in the reverse order of removal.
Rear Side
1. Disconnect the negative battery cable.
2. Remove the inner sail garnish. Inner Sail Garnish Removal/Installation
3. Remove the rear door trim. (See Removal and Replacement)
4. Remove the screw, and remove the power window subswitch from inside the front door trim.
5. Install in the reverse order of removal.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.