Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA2009CX-9 FWD V6-3.7LREPAIR AND DIAGNOSISSPECIFICATIONSMECHANICAL SPECIFICATIONSALIGNMENT
2009 Mazda CX-9 FWD V6-3.7L
Alignment
2009 Mazda CX-9 FWD V6-3.7LSECTION Alignment
FRONT WHEEL ALIGNMENT
Front wheel alignment [2WD] (Unloaded)*1
*1
Engine coolant and engine oil are at specified level. Spare tire, jack and tools are in designated position.
*2
Difference between left and right must not exceed 1° 30' prime.
Front wheel alignment [AWD] (Unloaded)*1
*1
Engine coolant and engine oil are at specified level. Spare tire, jack and tools are in designated position.
*2
Difference between left and right must not exceed 1° 30' prime.
REAR WHEEL ALIGNMENT
Rear wheel alignment [2WD] (Unloaded) *1
*1
Engine coolant and engine oil are at specified level. Spare tire, jack and tools are in designated position.
*2
Difference between left and right must not exceed 1° 30 prime.
Rear wheel alignment [AWD] (Unloaded) *1
*1
Engine coolant and engine oil are at specified level. Spare tire, jack and tools are in designated position.
*2
Difference between left and right must not exceed 1° 30' prime.
RIDE HEIGHT
Measure height H from the center of the wheel to the fender brim.
Verify that the difference between the left and right dimension H is within the specification.
Standard 10 mm {0.39 in} or less
Front wheel alignment [2WD] (Unloaded)*1
*1
Engine coolant and engine oil are at specified level. Spare tire, jack and tools are in designated position.
*2
Difference between left and right must not exceed 1° 30' prime.
Front wheel alignment [AWD] (Unloaded)*1
*1
Engine coolant and engine oil are at specified level. Spare tire, jack and tools are in designated position.
*2
Difference between left and right must not exceed 1° 30' prime.
REAR WHEEL ALIGNMENT
Rear wheel alignment [2WD] (Unloaded) *1
*1
Engine coolant and engine oil are at specified level. Spare tire, jack and tools are in designated position.
*2
Difference between left and right must not exceed 1° 30 prime.
Rear wheel alignment [AWD] (Unloaded) *1
*1
Engine coolant and engine oil are at specified level. Spare tire, jack and tools are in designated position.
*2
Difference between left and right must not exceed 1° 30' prime.
RIDE HEIGHT
Measure height H from the center of the wheel to the fender brim.
Verify that the difference between the left and right dimension H is within the specification.
Standard 10 mm {0.39 in} or less
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.