Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA2009CX-9 FWD V6-3.7LREPAIR AND DIAGNOSISCRUISE CONTROLCRUISE CONTROL SWITCHTESTING AND INSPECTION
2009 Mazda CX-9 FWD V6-3.7L
Cruise Control Switch: Testing and Inspection
2009 Mazda CX-9 FWD V6-3.7LSECTION Testing and Inspection
CRUISE CONTROL SWITCH INSPECTION [MZI-3.7]
1. Disconnect the negative battery cable wait for 1 min more.
2. Remove the driver-side air bag module. Driver-Side Air Bag Module Removal/Installation
3. Disconnect the cruise control switch connector. Service and Repair
4. Inspect for resistance and continuity between cruise control switch terminals B-C using a tester.
- If not as specified, replace the audio control switch. Service and Repair
5. Apply battery positive voltage to audio control switch terminal D, and connect terminal E to ground.
6. Verify that the LED illuminates.
- If the LED does not illuminate, replace the audio control switch. Service and Repair
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.