2009 Mazda B4000 AutomaticFACTORY OEM SERVICE PROCEDURE

Parking Light Bulb Removal/Installation: Notes

WARNING: This page is about a different car, the 2004 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable.
  2. Remove in the order indicated in the table/figure.
    REMOVING/INSTALLING PARKING LIGHT BULB (1)

    Component/Step No. Component Description
    1 Socket (See SOCKET REMOVAL NOTE (LEFT SIDE ONLY)Β )
    2 Parking light bulb
    3 Connector
    (1) See Fig 1.
    Fig 1: Removing/Installing Parking Light Bulb
    G02564045Courtesy of MAZDA MOTORS CORP.
  3. Install in the reverse order of removal.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.