2009 Mazda B2300 AutomaticFACTORY OEM SERVICE PROCEDURE

Pinpoint Test Pc: Data Link Diagnostics Test

DATA LINK DIAGNOSTICS TEST - PINPOINT TEST REFERENCE

PINPOINT TEST PC DATA LINK DIAGNOSTICS TEST
STEP INSPECTION ACTION
PC1 DATA LINK DIAGNOSTICS TEST
  • Key ON.
  • Carry out the IDS or equivalent tester data link test.
  • Is system passed obtained? 
Yes Test passed. Return to the Symptom Chart for the module in question.
No If controller area network (CAN) circuits faults; all electronic control units no response/not equipped, See PINPOINT TEST 5: NO CONTROLLER AREA NETWORK (CAN) COMMUNICATION , . If international standards organization (ISO) 9141 communications network circuit fault; all electronic control units no response/not equipped, see PINPOINT TEST 6: NO INTERNATIONAL STANDARDS ORGANIZATION (ISO) 9141 COMMUNICATIONS NETWORK COMMUNICATION , . If no response from the IDS or equivalent tester, see PINPOINT TEST 6: NO INTERNATIONAL STANDARDS ORGANIZATION (ISO) 9141 COMMUNICATIONS NETWORK COMMUNICATION , . If only one module does not communicate with the IDS or equivalent tester, see SYMPTOM TROUBLESHOOTING CHART - COMMUNICATIONS NETWORK , .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.