Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Mazda 6 s TouringFACTORY OEM SERVICE PROCEDURE
Abs/TCS HU/Cm Removal/Installation: Notes
CAUTION:
- When replacing the ABS/TCS HU/CM, the configuration procedure must be done before removing the ABS/TCS HU/CM. If the configuration is not completed before removing the ABS/TCS HU/CM, ABS/TCS will not work properly after installation of the ABS/TCS HU/CM.
- The internal parts of the ABS/TCS HU/CM could be damaged if dropped. Be careful not to drop the ABS/TCS HU/CM. Replace the ABS/TCS HU/CM if it is subjected to an impact.
- Remove the following parts:
- Windshield wiper arm and blade. See WINDSHIELD WIPER ARM AND BLADE REMOVAL/INSTALLATION .
- Cowl grille. See COWL GRILLE REMOVAL/INSTALLATION .
- Windshield wiper motor. See WINDSHIELD WIPER MOTOR REMOVAL/INSTALLATION .
- Cowl panel. See COWL PANEL REMOVAL/INSTALLATION .
- For the vehicles with MZI-3.7, remove the power steering reserve tank component. See POWER STEERING OIL PUMP REMOVAL/INSTALLATION [MZI-3.7] .
- Remove in the order indicated in the table.
- Install in the reverse order of removal.
- Add brake fluid, bleed the brakes, and inspect for leakage after the installation has been completed. See AIR BLEEDING .
- Configurate the ABS/TCS HU/CM (only when replacing it). See ABS/TCS HU/CM CONFIGURATIONΒ .
- Clear the DTCs from the memory. See ON-BOARD DIAGNOSIS [ABS/TCS] .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
