Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Power Window System Customized Function Setting Procedure
2009 Mazda 6 V6-3.7LSECTION Power Window System Customized Function Setting Procedure
POWER WINDOW SYSTEM CUSTOMIZED FUNCTION SETTING PROCEDURE
Two-step Down Function Operative/Non-operative Switching
NOTE:
- By following the procedure below, the two-step down function is switched to non-operative when it is operative, and to operative when it is non-operative.
Door Glass Position Change
NOTE:
- After performing the following procedure, verify that the two-step down function operates normally and the door glass position has changed. If the two-step down function does not operate or the door glass position has not changed, the procedure was not performed properly. Repeat the procedure from the beginning.
Exterior Open/Close Function Switching
- The switching of exterior open/close function is controlled by the BCM. (See Programming and Relearning)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.