Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20096 V6-3.7LREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSACCELERATOR PEDAL POSITION SENSORTESTING AND INSPECTION
2009 Mazda 6 V6-3.7L
Accelerator Pedal Position Sensor: Testing and Inspection
2009 Mazda 6 V6-3.7LSECTION Testing and Inspection
ACCELERATOR PEDAL POSITION (APP) SENSOR INSPECTION [MZI-3.7]
Sensor Output Value Inspection
1. Switch the ignition to ON.
2. Inspect the following items using the PID/DATA monitor function. Diagnostic Monitoring Test Results
- Verify that the sensor output value change smoothly while throttle valve is gradually depressed.
- APP1
- APP2
- If verified, go to the next step.
- If not as verified, replace the accelerator pedal. Service and Repair
- Verify that the sensor output value is as indicated in the table below according to the condition of the accelerator pedal.
- APP1
- APP2
- If not as verified, replace the accelerator pedal. Service and Repair
Specification
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.