Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Mazda 6 V6-3.7LFACTORY OEM SERVICE PROCEDURE
Lighting System Personalization Features Setting Procedure
LIGHTING SYSTEM PERSONALIZATION FEATURES SETTING PROCEDURE
Auto light system / auto light-off system
NOTE:
- Use the IDS (laptop PC) because the PDS (Pocket PC) does not support the PERSONALIZATION FEATURES SETTING PROCEDURE.
1. Connect the M-MDS to the DLC-2.
2. After the vehicle is identified, select the following items from the initial screen of the M-MDS.
- Select the "Module Programming"
3. Then, select items from the screen menu in the following order.
- Select "Programmable Parameters"
- Select "Exterior Lighting"
4. Select the item name, and then select option.
Room light control system / turn light system
- For the room light control system / turn light system, refer to the control system personalization features setting. Programming and Relearning
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.