Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA2008TRIBUTE S SPORT, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1838 (MODULE CONFIGURATION SYSTEM)GENERAL PROCEDURESACCESSORY PROTOCOL INTERFACE MODULE (APIM) PROGRAMMINGACCESSORY PROTOCOL INTERFACE MODULE (APIM) PROGRAMMING USING THE INTEGRATED DIAGNOSTIC SYSTEM (IDS)
2008 Mazda Tribute s Sport, 4WD
Accessory Protocol Interface Module (APIM) Programming Using the Integrated Diagnostic System (IDS)
2008 Mazda Tribute s Sport, 4WDSECTION Accessory Protocol Interface Module (APIM) Programming Using the Integrated Diagnostic System (IDS)
WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
If a new Accessory Protocol Interface Module (APIM) is being installed, install the new APIM before carrying out the following procedure. For additional information, refer to REMOVAL AND INSTALLATION
.
- Turn the Audio Control Module (ACM) on.
- Connect the scan tool to the Data Link Connector (DLC).
- Connect one end of the Universal Serial Bus (USB) male-A to male-A cable to the scan tool.
- Connect the other end of the USB male-A to male-A cable to the vehicle USB port.
- From the technician service publication website, run On-Line Automotive Service Information System (OASIS) using Quick Start or by manually entering the Vehicle Identification Number (VIN).
- From the OASIS tab, select the "Sync/APIM" bullet.
- Select the "Read APIM" button to verify the current APIM Vehicle Interface Processor (VIP) and Consumer Interface Processor (CIP) software levels.
- Select the desired software level from the list of available software for programming then select the "Program APIM" button to begin the APIM programming process. Enter the APIM As-Built data if prompted.
- When only the CIP is being programmed, select cancel when prompted whether or not to program the VIP.
- When the VIP is programmed, the CIP will be programmed automatically.
NOTE: Do not disconnect the Vehicle Communication Module (VCM) or USB cables during APIM programming. - The Sync/APIM application downloads the software into the APIM and displays "Programming has been completed successfully".
- Test the audio system for correct operation.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.