Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Mazda RX8 2RTR-1.3LFACTORY OEM SERVICE PROCEDURE
After Service Precaution
AFTER REPAIR PRECAUTION
Fuel Leakage Inspection
WARNING: Fuel vapor is hazardous. It can very easily ignite, causing serious injury and damage. Fuel can also irritate skin and eyes. To prevent this, always complete the "Fuel Line Inspection".
CAUTION: Shorting the wrong terminal of the check connector may cause malfunctions. Make sure to short only the specified terminal.

1. Ground the check connector terminal F/P to the body using a jumper wire.
2. Turn the ignition switch to the ON position and operate the fuel pump.
3. Verify that there is no fuel leakage from the pressurized parts.
- If there is leakage, replace the fuel hoses.
- If there is damage to the seal on the fuel pipe side, replace the fuel pipe.
Fuel Leakage
There shall be no leakage after 5 min.
4. After reinstallation, repeat Step 1-3 of the fuel leakage inspection.
Fuel Leakage Inspection
WARNING: Fuel vapor is hazardous. It can very easily ignite, causing serious injury and damage. Fuel can also irritate skin and eyes. To prevent this, always complete the "Fuel Line Inspection".
CAUTION: Shorting the wrong terminal of the check connector may cause malfunctions. Make sure to short only the specified terminal.
1. Ground the check connector terminal F/P to the body using a jumper wire.
2. Turn the ignition switch to the ON position and operate the fuel pump.
3. Verify that there is no fuel leakage from the pressurized parts.
- If there is leakage, replace the fuel hoses.
- If there is damage to the seal on the fuel pipe side, replace the fuel pipe.
Fuel Leakage
There shall be no leakage after 5 min.
4. After reinstallation, repeat Step 1-3 of the fuel leakage inspection.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
