2008 Mazda B2300 L4-2.3LFACTORY OEM SERVICE PROCEDURE

Crankshaft Position Sensor: Service and Repair

CRANKSHAFT POSITION (CKP) SENSOR REMOVAL / INSTALLATION - 2.3L

Factory service manual diagram





Removal
1. With the vehicle in NEUTRAL, position it on a hoist. See LIFTING.
2. Disconnect the negative battery cable.

Factory service manual diagram





3. Disconnect the crankshaft position (CKP) sensor electrical connector.

Factory service manual diagram





4. Remove the plug for the crankshaft timing peg SST.

Factory service manual diagram





5. Install the special tool and turn the crankshaft pulley bolt to position the number one cylinder at top dead center.

Factory service manual diagram





6. Install the M6 bolt (1F2012-428).

NOTE: A new CKP sensor must be installed when ever the old sensor is removed.

7. Remove the CKP.

Factory service manual diagram





8. Install an M6 bolt.

Installation

NOTE: A new CKP sensor must be installed when ever the old sensor is removed.

Factory service manual diagram





1. Install a new CKP, but do not tighten the bolts at this time.

Factory service manual diagram





2. Adjust the CKP with the Crankshaft Position Sensor Alignment Jig and tighten the bolts.

Factory service manual diagram





3. Connect the CKP electrical connector.

Factory service manual diagram





4. Remove the M6 bolt.

Factory service manual diagram





5. Remove the crankshaft timing peg SST.

Factory service manual diagram





6. Install the plug for the crankshaft timing peg.

Factory service manual diagram



Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.