Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20086 I GRAND TOURING, 4D HATCHBACK, AUTOMATICREPAIR AND DIAGNOSISENGINE PERFORMANCEENGINE CONTROL SYSTEMSENGINE CONTROL SYSTEM (L3)PCM CONFIGURATION [L3]
2008 Mazda 6 i Grand Touring, 4D Hatchback, Automatic
Pcm Configuration [L3]
2008 Mazda 6 i Grand Touring, 4D Hatchback, AutomaticSECTION Pcm Configuration [L3]
- Connect the M-MDS to the DLC-2.
- After the vehicle is identified, select the following items from the initial screen of the M-MDS.
- When using the IDS (laptop PC)
- Select the "Module Programming".
- When using the PDS (Pocket PC)
- Select "Programming".
- Select "Module Programming".
- When using the IDS (laptop PC)
- Then, select the "Programmable Module Installation", "PCM" from the screen menu.
- Select "PCM" and perform procedures according to directions on the M-MDS screen.
- Retrieve DTCs by the M-MDS, then verify that there is no DTC present.
- If a DTC is present, perform the applicable DTC inspection.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.