Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Mazda 5 L4-2.3LFACTORY OEM SERVICE PROCEDURE
Procedures
BATTERY RECHARGING [L3]
WARNING
- Keep all flames away from the battery, otherwise evaporated gas from the battery fluid may catch fire, and cause serious injury.
- Remove the battery filler caps when recharging to prevent battery deformation or damage.
CAUTION: Do not quick charge for more than 30 min It will damage the battery.

1. Remove the battery and then place it in a pan of water.
2. Remove the battery filler caps.
3. Connect a battery charger to the battery and adjust the charging current as follows.
Battery slow charge current
55D23L (48): 4.5-5.5 A
80D26L (55): 5.5-6.5 A
Battery quick charge current [30 mini]
55D23L (48): 30 A
80D26L (55): 35 A
4. After the battery is recharged, verify that the voltage is within the specification and remains at the same value for 1 h or more after the recharging was completed.
- If not within the specification, replace the battery.
Standard voltage
12.4 V or more
WARNING
- Keep all flames away from the battery, otherwise evaporated gas from the battery fluid may catch fire, and cause serious injury.
- Remove the battery filler caps when recharging to prevent battery deformation or damage.
CAUTION: Do not quick charge for more than 30 min It will damage the battery.
1. Remove the battery and then place it in a pan of water.
2. Remove the battery filler caps.
3. Connect a battery charger to the battery and adjust the charging current as follows.
Battery slow charge current
55D23L (48): 4.5-5.5 A
80D26L (55): 5.5-6.5 A
Battery quick charge current [30 mini]
55D23L (48): 30 A
80D26L (55): 35 A
4. After the battery is recharged, verify that the voltage is within the specification and remains at the same value for 1 h or more after the recharging was completed.
- If not within the specification, replace the battery.
Standard voltage
12.4 V or more
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
