Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Mazda 5 L4-2.3LFACTORY OEM SERVICE PROCEDURE
Flywheel
Drive Plate (ATX), Flywheel (MTX) Assembly
Tighten the bolts in the 3 steps in the figure.
Tightening torque
(1) 46-54 N-m (4.70-5.50 kgf-m, 34.0-39.8 ft-lbf)
(2) 76-84 N-m (7.75-8.56 kgf-m, 56.1-61.9 ft-lbf)
(3) 108-116 N-m (11.1 -11.8 kgf-m, 79.7-85.5 ft-lbf)
Tighten the bolts in the 3 steps in the figure.
Tightening torque
(1) 46-54 N-m (4.70-5.50 kgf-m, 34.0-39.8 ft-lbf)
(2) 76-84 N-m (7.75-8.56 kgf-m, 56.1-61.9 ft-lbf)
(3) 108-116 N-m (11.1 -11.8 kgf-m, 79.7-85.5 ft-lbf)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.