Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Mazda 5 L4-2.3LFACTORY OEM SERVICE PROCEDURE
Oil Pump, Engine
Oil Pump bolts
Tighten the oil pump bolts in two steps in the order indicated in the figure.
Tightening torque:
(1) 8-12 N-m (82-122 kgf-cm, 71-105 in-lbf)
(2) 17-23 N-m (1.8-2.3 kgf-m, 12.6-16.9 ft-lbf)
Tighten the oil pump bolts in two steps in the order indicated in the figure.
Tightening torque:
(1) 8-12 N-m (82-122 kgf-cm, 71-105 in-lbf)
(2) 17-23 N-m (1.8-2.3 kgf-m, 12.6-16.9 ft-lbf)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.