Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Mazda RX8 2RTR-1.3LFACTORY OEM SERVICE PROCEDURE
Mechanical Specifications
Specification
Standard plug gap 1.15-1.25 mm (0.046-0.049 in)
Maximum plug gap
Leading side 1.5 mm {0.059 in}
Trailing side 1.4 mm {0.055 in}
Tightening torque 12.8-17.7 N.m {131-180 kgf-cm, 114 - 156 in-lbf}
Spark Plug Inspection:
Standard plug gap 1.15-1.25 mm (0.046-0.049 in)
Maximum plug gap
Leading side 1.5 mm {0.059 in}
Trailing side 1.4 mm {0.055 in}
Tightening torque 12.8-17.7 N.m {131-180 kgf-cm, 114 - 156 in-lbf}
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.