Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Mazda RX8 2RTR-1.3LFACTORY OEM SERVICE PROCEDURE
Camber Adjustment
Camber Adjustment
Caution:
^ Adjust the camber before adjusting the caster.
Note:
^ The camber and caster change largely if the front cam is adjusted due to the suspension construction. If the rear cam is adjusted, the caster largely, however, the camber barely changes. Therefore, adjust the camber (front cam) and then the caster (rear cam) to adjust the alignment efficiently.
1. Loosen the fixing nut of the adjusting cam bolt (front lower arm front side).
2. Rotate the adjusting cam bolt in either direction to adjust the camber.
* : From the end of the front fender to the center of the wheel (mm {in})
Note: Refer to the figure for the adjusting angle per one graduation.
3. Tighten the nut.
Tightening torque 117.7-137.3 N-m (12.1-14.0 kgf.m, 86.9-101.2 ft-lbf)
4. Adjust the toe-in.
Caution:
^ Adjust the camber before adjusting the caster.
Note:
^ The camber and caster change largely if the front cam is adjusted due to the suspension construction. If the rear cam is adjusted, the caster largely, however, the camber barely changes. Therefore, adjust the camber (front cam) and then the caster (rear cam) to adjust the alignment efficiently.
1. Loosen the fixing nut of the adjusting cam bolt (front lower arm front side).
2. Rotate the adjusting cam bolt in either direction to adjust the camber.
Standard Suspension:
Sport Suspension:
* : From the end of the front fender to the center of the wheel (mm {in})
Note: Refer to the figure for the adjusting angle per one graduation.
3. Tighten the nut.
Tightening torque 117.7-137.3 N-m (12.1-14.0 kgf.m, 86.9-101.2 ft-lbf)
4. Adjust the toe-in.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.