Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Mazda Mazdaspeed3 L4-2.3L TurboFACTORY OEM SERVICE PROCEDURE
Technical Data A26M-R
TECHNICAL DATA
Secondary shaft (NO.1) gear thrust clearance
Secondary shaft (NO.1) gear radial clearance
Secondary shaft (NO.2) gear thrust clearance
Secondary shaft (NO.2) gear radial clearance
Reverse idler gear thrust clearance
Reverse idler gear radial clearance
Synchronizer ring clearance
Clutch hub sleeve and shift fork clearance
Primary shaft snap ring clearance
Secondary shaft (NO.1) snap ring clearance
Secondary shaft (NO.2) snap ring clearance
Gear backlash
Bearing rotational torque
Secondary shaft (NO.1) gear thrust clearance
Secondary shaft (NO.1) gear radial clearance
Secondary shaft (NO.2) gear thrust clearance
Secondary shaft (NO.2) gear radial clearance
Reverse idler gear thrust clearance
Reverse idler gear radial clearance
Synchronizer ring clearance
Clutch hub sleeve and shift fork clearance
Primary shaft snap ring clearance
Secondary shaft (NO.1) snap ring clearance
Secondary shaft (NO.2) snap ring clearance
Gear backlash
Bearing rotational torque
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.