Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Mazda CX-7 Touring, FWDFACTORY OEM SERVICE PROCEDURE
Manifold Absolute Pressure (Map) Sensor/Boost Air Temperature Sensor Removal/Installation
- Disconnect the negative battery cable.
- Remove the charge air cooler duct. (See INTAKE AIR SYSTEM REMOVAL/INSTALLATION ).
- Remove the oil level gauge pipe. (See OIL PAN REMOVAL/INSTALLATION ).
- Disconnect the MAP/boost air temperature sensor connector.
- Remove MAP/boost air temperature sensor from the intake manifold.
- Install in the reverse order of removal.
Tightening torque
5.0-7.0 N.m {51-71 kgf.cm, 45-61 in.lbf}
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.