Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2007 Mazda CX-7 Touring, FWDFACTORY OEM SERVICE PROCEDURE

Front Abs Wheel-Speed Sensor Removal/Installation

Perform the following procedure and remove the LF ABS wheel-speed sensor.
1. Remove the battery and battery tray.
2. Remove the air cleaner component and air hose. (See INTAKE AIR SYSTEM REMOVAL/INSTALLATION[L3 WITH TC] ).
Remove in the order indicated in the figure.
Install in the reverse order of removal.

Fig 1: Front ABS Wheel-Speed Sensor Replacement Components With Torque Specifications
Courtesy of MAZDA MOTORS CORP.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.