Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Mazda CX-7 L4-2.3L TurboFACTORY OEM SERVICE PROCEDURE
Total Toe-In Adjustment
Total Toe-in Adjustment
1. Loosen the securing nut of the adjusting cam bolt.

2. Rotate the adjusting cam bolt in either direction to adjust the toe-in.

3. Tighten the nut.
Tightening torque 80 - 100 N-m (8.2 - 10.1 kgf-m, 59.1 - 73.7 ft-lbf)
1. Loosen the securing nut of the adjusting cam bolt.
2. Rotate the adjusting cam bolt in either direction to adjust the toe-in.
3. Tighten the nut.
Tightening torque 80 - 100 N-m (8.2 - 10.1 kgf-m, 59.1 - 73.7 ft-lbf)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
