2007 Mazda CX-7 L4-2.3L TurboFACTORY OEM SERVICE PROCEDURE

Keyless Control Module [Advanced Keyless System]

KEYLESS CONTROL MODULE REMOVAL/INSTALLATION[ADVANCED KEYLESS SYSTEM]

NOTE:
- If the keyless control module is replaced, always perform the following procedure.
Without immobilizer system
- Card key programming.
- Steering lock unit programming.

With immobilizer system
- Card key programming.
- Steering lock unit programming.
- Immobilizer system resetting (with immobilizer system).

Factory service manual diagram



1. Disconnect the negative battery cable.
2. Remove the front side trim.
3. Disconnect the keyless control module connector.
4. Remove the bolt, then remove the keyless control module.
5. Install in the reverse order of removal.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.