2007 Mazda B3000 Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Camshaft Position (CMP) Sensor Removal / Installation - 3.0L

Fig 1: Camshaft Position (CMP) Sensor Replacement Components With Torque Specifications - 3.0L
G04930157Courtesy of MAZDA MOTORS CORP.
  1. Disconnect negative battery cable. See BATTERY DISCONNECT .
  2. Disconnect the connector the camshaft position (CMP) sensor electrical connector.
    Fig 2: Disconnecting Camshaft Position (CMP) Sensor Electrical Connector
    G04930158Courtesy of MAZDA MOTORS CORP.
  3. Remove the screws and the CMP sensor.
    Fig 3: View Of CMP Sensor
    G04930159Courtesy of MAZDA MOTORS CORP.
  4. Install in reverse order of removal.

    Tightening torque 

    2.5-3.5 N.m { 26-36 kgf.cm, 23-30 in.lbf } 

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.