Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Mazda B3000 Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Electrical Component Locator: Grounds
GROUNDS LOCATION
| Component | Location |
|---|---|
| G1 | Behind left headlight. See Figure. |
| G2 | At center rear of engine compartment. See Figure. |
| G3 | At left rear corner of engine compartment. See Figure. |
| G4 | Behind left headlight. See Figure. |
| G5 | At right rear corner of engine compartment. See Figure. |
| G6 | Behind left headlight. See Figure. |
| G8 | Under center of dash. See Figure. |
| G9 | At left kick panel. See Figure. |
| G10 | Under driver's seat. See Figure. |
| G11 | At right kick panel. See Figure. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.