Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Mazda 6 s, 4D Hatchback, AutomaticFACTORY OEM SERVICE PROCEDURE
When idling cannot be continued
NOTE:
- Inspect for each bank
- Remove the OCV and verify that the spool valve is at maximum retard position.
- If the spool valve is stuck in advance direction, replace the OCV. (See OIL CONTROL VALVE (OCV) REMOVAL/INSTALLATION ).
- Connect the OCV.
- Turn the ignition switch to ON position.
- Verify that the spool valve is at max. retard position.
- If the spool valve is stuck in advance direction, inspect the following:
- Short circuit in harnesses or connectors between the OCV and the PCM.
- If the spool valve is stuck in advance direction, inspect the following:
- Inspect the variable valve timing actuator.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
