Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Mazda 6 i, 4D Hatchback, AutomaticFACTORY OEM SERVICE PROCEDURE
Variable Tumble System Operation Inspection
- Connect the M-MDS to the DLC-2.
- Access ECT PID.
- Verify that ECT PID is below 60°C {140°F} .
- Start the engine.
- Inspect rod operation under the following conditions:
Rod operation
ROD OPERATION
| Engine speed | 3,750 RPM | |
| Below | Above | |
| Shutter valve actuator | Operate | Not operate |
- If the rod operation is not specified, inspect as follows:
- Verify that DTC No. P2004, P2006, P2009 or P2010 is not displayed.
- If DTC No. P2009 or P2010 are shown, perform DTC inspection.
(See DTC TABLE ).
- If DTC No. P2009 or P2010 are shown, perform DTC inspection.
- Inspect Variable tumble solenoid valve.
(See VARIABLE TUMBLE SOLENOID VALVE INSPECTION ).
- If the Variable tumble solenoid valve is not okay, replace Variable tumble solenoid valve.
- If the Variable tumble solenoid valve is okay, inspect the following:
- Vacuum hose and vacuum chamber for looseness or damage
- Shutter valve actuator
- Shutter valve stuck open or closed
- Verify that DTC No. P2004, P2006, P2009 or P2010 is not displayed.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
