Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Mazda 6 V6-3.0LFACTORY OEM SERVICE PROCEDURE
Engine Temperature Sensor: Testing and Inspection
ENGINE COOLANT TEMPERATURE (ECT) SENSOR INSPECTION[AJ]
NOTE: Perform the following inspection only when directed.
Resistance Inspection
1. Remove the ECT sensor.
2. Place the ECT sensor in water with a thermometer. and heat the water gradually.
3. Measure the resistance between ECT sensor terminals A and B using an ohmmeter.
- If the ECT sensor is okay, but the PID value is out of specification, perform the "Circuit Open Short Inspection".
- If not as specified, replace the ECT sensor.
Circuit Open/Short Inspection
1. Disconnect the PCM connector.
2. Inspect the following harnesses for open or short circuit. (Continuity check)
Open circuit
- ECT sensor terminal A and PCM terminal 2AQ
- ECT sensor terminal B and PCM terminal 2AJ
Short circuit
- ECT sensor terminal A and power supply
- ECT sensor terminal A and body ground
- ECT sensor terminal B and power supply
NOTE: Perform the following inspection only when directed.
Resistance Inspection
1. Remove the ECT sensor.
2. Place the ECT sensor in water with a thermometer. and heat the water gradually.
Measure The ECT Sensor Resistance:
3. Measure the resistance between ECT sensor terminals A and B using an ohmmeter.
- If the ECT sensor is okay, but the PID value is out of specification, perform the "Circuit Open Short Inspection".
- If not as specified, replace the ECT sensor.
Circuit Open/Short Inspection
1. Disconnect the PCM connector.
2. Inspect the following harnesses for open or short circuit. (Continuity check)
Open circuit
- ECT sensor terminal A and PCM terminal 2AQ
- ECT sensor terminal B and PCM terminal 2AJ
Short circuit
- ECT sensor terminal A and power supply
- ECT sensor terminal A and body ground
- ECT sensor terminal B and power supply
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.