2007 Mazda 6 MazdaspeedFACTORY OEM SERVICE PROCEDURE

L3 With TC

MULTIPLEX COMMUNICATION DIAGNOSTIC TROUBLE CODE (DTC) LIST - L3 WITH TC

DTC Malfunction location DTC output module Action
U0073 CAN system communication error
  • PCM
  • DSC HU/CM
  • AWD control module
  • Keyless control module
(See DTC U0073, U2516 [L3 WITH TC] )
U0100 Communication error to PCM
  • DSC HU/CM
  • AWD control module
  • Keyless control module
(See PROCEDURES FOR DETERMINING THE LOCATION OF A MALFUNCTION [L3 WITH TC] )
U0114 Communication error to AWD control module DSC HU/CM
U0121 Communication error to DSC HU/CM
  • PCM
  • AWD control nodule
U0155 Communication error to instrument cluster
  • PCM
  • DSC HU/CM
U0323 Communication error to instrument cluster Keyless control module
U1900 Communication error to other modules Instrument cluster (See PROCEDURES FOR DETERMINING THE LOCATION OF A MALFUNCTION [L3 WITH TC] )
U2023 Abnormal message from PCM Keyless control module
U2511 Abnormal message from AWD control module DSC HU/CM
U2516 CAN system communication error Instrument cluster (See DTC U0073, U2516 [L3 WITH TC] )
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.