Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Mazda 6 MazdaspeedFACTORY OEM SERVICE PROCEDURE
Immobilizer System With Keyless Entry System
ENGINE IMMOBILIZER DIAGNOSTIC TROUBLE CODE (DTC) LIST - WITH KEYLESS ENTRY SYSTEM
| DTC | Description |
|---|---|
| DTC B1681) | Coil signal is not received. |
| DTC B2103) | Coil failure. |
| DTC B1600) | ID number signal is not received. |
| DTC B2431) | Transponder programming failure. |
| DTC B1602) | PCM received invalid format of ID number from transponder. |
| DTC B1601) | PCM received incorrect ID number from key (transponder). |
| DTC B1213) | Number of valid keys is below minimum. |
| DTC B1342) | PCM is defective. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
