2007 Mazda 6 MazdaspeedFACTORY OEM SERVICE PROCEDURE

Steering Angle Sensor Inspection

WARNING: This page is about a different car, the 2008 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the column cover.
  2. Turn the ignition switch to the ON position and measure the voltage between steering angle sensor terminal A and ground.
    • If there is any malfunction, inspect the wiring harness between steering angle sensor terminal A and DSC HU/CM terminal AB. Repair or replace if necessary.

    Standard voltage B+Β 

  3. Measure the voltage between steering angle sensor terminal D and ground.
    • If there is any malfunction, inspect the wiring harness between steering angle sensor terminal D and DSC HU/CM terminal AH. Repair or replace if necessary.
      Fig 1: Identifying Steering Angle Sensor Connector Terminals
      G04955752Courtesy of MAZDA MOTORS CORP.

    Standard voltage 0VΒ 

  4. Turn the ignition switch off.
  5. Connect the M-MDS to the DLC-2.
  6. Select the "SWA_POS" PID.
  7. Verify the SWA_POS changes when the steering wheel is turned to the left and right.
    • If there is any malfunction, replace the steering angle sensor. (See CLOCK SPRING REMOVAL/INSTALLATION .)
      Fig 2: Identifying DLC-2 Connector
      G04955753Courtesy of MAZDA MOTORS CORP.

    Standard When the steering wheel is turned to the left: SWA_POS changes positively.Β 

    When the steering wheel is turned to the right: SWA_POS changes negatively.Β 

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.