2007 Mazda 6 MazdaspeedFACTORY OEM SERVICE PROCEDURE

Brake Fluid Pressure Sensor Initialization Procedure

WARNING: This page is about a different car, the 2007 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
  • If the initialization procedure is not completed, the DSC will not operate properly and it might cause an unexpected accident. Therefore, after replacing or removing the DSC HU/CM, make sure to perform the initialization procedure to insure proper DSC operation.
  1. Turn the ignition switch off.
  2. Connect the M-MDS to the DLC-2.
  3. After the vehicle is identified, select the following items from the initial screen of the M-MDS.
    • When using the IDS (laptop PC)
      1. Select "Chassis".
      2. Select "ABS/DSC".
      3. Select "Sensor Initialization".
    • When using the PDS (Pocket PC)
      1. Select "Module Tests".
      2. Select "ABS".
      3. Select "DataLogger".
      4. Select "MCYL_S_CAL".
  4. Perform the initialization procedure according to the directions on the screen.
  5. Drive the vehicle.
  6. After 5 min or moreΒ  of driving, verify that the DSC system is normal.
    Fig 1: Identifying DLC-2 Connector
    G04955736Courtesy of MAZDA MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.