2007 Mazda 6 MazdaspeedFACTORY OEM SERVICE PROCEDURE

Top Lock Switch Inspection[Advanced Keyless System]

WARNING: This page is about a different car, the 2007 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front header trim. (See FRONT HEADER TRIM REMOVAL/INSTALLATION .)
  2. Disconnect the striker switch connector.
  3. Verify that the continuity between the striker switch terminals is as indicated in the table.
    • If not as indicated in the table, replace the striker.

    : Continuity

    Fig 1: Striker Switch Continuity Chart
    G04931376Courtesy of MAZDA MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.