2007 Mazda 6 MazdaspeedFACTORY OEM SERVICE PROCEDURE

Security Access Procedure[Advanced Keyless System]

WARNING: This page is about a different car, the 2007 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the M-MDS to the DLC-2.
  2. Select "BODY/SECURITY/PATS functions" from the M-MDS screen menu.
  3. Select the items to be performed from the following:
    • Program Additional card key
    • Card Key Code Erase
    • Steering Lock Unit Programming
    • Program additional ignition key (with immobilizer system)
    • Ignition Key Code Erase (with immobilizer system)
    • Customer Spare Key Programming Enable (with immobilizer system)
    • Customer Spare Key Programming Disable (with immobilizer system)
  4. The security access begins and the M-MDS displays the "OUT-CODE".
    Fig 1: Identifying DLC-2 Connector
    G04931205Courtesy of MAZDA MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.