2007 Mazda 6 MazdaspeedFACTORY OEM SERVICE PROCEDURE

Request Switch Removal/Installation[Advanced Keyless System]: Deiver-side/passenger-side

WARNING: This page is about a different car, the 2007 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [LF] .)
  2. Remove the door trim. (See DOOR TRIM REMOVAL/INSTALLATION .)
  3. Remove the outer handle. (See OUTER HANDLE REMOVAL/INSTALLATION[ADVANCED KEYLESS SYSTEM]Β .)
  4. Remove the screws A, then remove the handle seat and plate.
  5. Remove screw B, then remove the request switch.
  6. Install in the reverse order of removal.
Fig 1: Identifying Request Switch Remove/Install Components (Driver-Side/Passenger-Side)
G04931359Courtesy of MAZDA MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.