Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Mazda 6 MazdaspeedFACTORY OEM SERVICE PROCEDURE
Open Hook Removal/Installation[Advanced Keyless System]
WARNING: This page is about a different car, the 2007 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the following parts:
- Console (See CONSOLE REMOVAL/INSTALLATION .)
- Quarter trim (See QUARTER TRIM REMOVAL/INSTALLATION .)
- Scuff plate (See SCUFF PLATE REMOVAL/INSTALLATION .)
- Tire house trim (See TIRE HOUSE TRIM REMOVAL/INSTALLATION .)
- Aeroboard (See AEROBOARD REMOVAL/INSTALLATION .)
- Seat back bar garnish (See SEAT BACK BAR GARNISH REMOVAL/INSTALLATION .)
- Back trim (See BACK TRIM REMOVAL/INSTALLATION .)
- Seat back bar lower garnish (See SEAT BACK BAR LOWER GARNISH REMOVAL/INSTALLATION .)
- Remove the bolts.
- Remove the open hook.
- Install in the reverse order of removal.
- Remove the following parts:
- Console (See CONSOLE REMOVAL/INSTALLATION .)
- Quarter trim (See QUARTER TRIM REMOVAL/INSTALLATION .)
- Scuff plate (See SCUFF PLATE REMOVAL/INSTALLATION .)
- Tire house trim (See TIRE HOUSE TRIM REMOVAL/INSTALLATION .)
- Aeroboard (See AEROBOARD REMOVAL/INSTALLATION .)
- Seat back bar garnish (See SEAT BACK BAR GARNISH REMOVAL/INSTALLATION .)
- Back trim (See BACK TRIM REMOVAL/INSTALLATION .)
- Seat back bar lower garnish (See SEAT BACK BAR LOWER GARNISH REMOVAL/INSTALLATION .)
- Remove the bolts.
- Remove the open hook.
- Install in the reverse order of removal.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
