2007 Mazda 6 MazdaspeedFACTORY OEM SERVICE PROCEDURE

Keyless Control Module CONFIGULATION[Advanced Keyless System]

WARNING: This page is about a different car, the 2007 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the M-MDS to the DLC-2 connector.
  2. After the vehicle is identified, select the following items from the initial screen of the M-MDS.
    • When using the IDS (laptop PC)
      1. Select "Module Programming".
    • When using the PDS (Pocket PC)
      1. Select "Programming".
      2. Select "Module Programming".
  3. Then, select the "Programmable Module Installation" and "RKE" from the screen menu.
  4. Perform the configuration according to the directions on the screen.
  5. Retrieve DTCs using the M-MDS, then verify if DTCs are present.
    Fig 1: Identifying DLC-2 Connector
    G04931205Courtesy of MAZDA MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.