Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Mazda 6 MazdaspeedFACTORY OEM SERVICE PROCEDURE
No.1 Additional Key Programming Procedure (Using Two Valid Keys): Procedure
WARNING: This page is about a different car, the 2007 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.
- Prepare key 3 for programming.
- Start the engine using key 1.
- Verify that the security light illuminates for approx. 3 sΒ , and then goes out.
- Turn the ignition switch to the LOCK position.
- Using key 1, turn the ignition switch to the ON position.
- Verify that the security light illuminates for approx. 3 s, and then goes out.
- Using key 1, turn the ignition switch to the LOCK position within approx. 4 sΒ after the security light goes out.
- Remove key 1.
- Repeat Steps 2-5 using key 2 instead of key 1.
- Repeat Steps 5-8 using key 3 instead of key 1.
- If additional keys need to be programmed, repeat Steps 1-10, and replace key 3 in Step 10 with the key to be programmed (key 4).
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
