2007 Mazda 6 MazdaspeedFACTORY OEM SERVICE PROCEDURE

M-MDS Connecting Procedure

WARNING: This page is about a different car, the 2007 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Do not place the M-MDS in the vehicle while programming, otherwise programming cannot be performed.
  1. Fully lower the door glass.
  2. Connect the M-MDS to the DLC-2.
  3. Pull out the M-MDS cable from the door glass opening and set the M-MDS outside the vehicle.
CAUTION:
  • Protect the cable and body contact area with a clean rag, otherwise they could be damaged.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.