2007 Mazda 6 MazdaspeedFACTORY OEM SERVICE PROCEDURE

Hood Latch Switch Inspection[Advanced Keyless System]

WARNING: This page is about a different car, the 2007 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open the hood.
  2. Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [LF] .)
  3. Disconnect the hood latch switch connector.
  4. Inspect for continuity between the hood latch switch terminals A and B.
    • If there is no continuity, replace the hood latch switch.
    Fig 1: Identifying Hood Latch Switch Terminals A And B
    G04928893Courtesy of MAZDA MOTORS CORP.
  5. Lock the hood latch using a flathead screwdriver or equivalent as shown.
  6. Inspect for continuity between the hood latch switch terminals A and B
    • If there is continuity, replace the hood latch.
    CAUTION:
    • After the inspection, unlock the hood latch. If closing the hood with the hood latch locked, the hood latch and/or hood striker may be broken.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.