2007 Mazda 6 MazdaspeedFACTORY OEM SERVICE PROCEDURE

Coil Antenna Removal/Installation[Advanced Keyless System]: Notes

WARNING: This page is about a different car, the 2007 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • Do not remove the coil antenna unless you are replacing it.
  • When only the coil antenna is replaced, the immobilizer system reprogram procedure is not necessary.
  1. Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [LF] .)
  2. Remove the column cover.
  3. Remove in the order indicated in the table.
    Fig 1: Identifying Coil Antenna And Connector
    G04931322Courtesy of MAZDA MOTORS CORP.
  4. Install in the reverse order of removal.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.