Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Mazda 6 MazdaspeedFACTORY OEM SERVICE PROCEDURE
With two programmed card keys
WARNING: This page is about a different car, the 2007 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.
- Bring the programmed card keys (2) and a unprogrammed card key into the vehicle.
- Close all doors.
- Insert the supplementary key into the ignition key cylinder.NOTE:
- Complete the procedures up to Step 7 within 30 s after the supplementary key is inserted.
- Turn the ignition switch to the ON position.
- Press the UNLOCK button on card key 1.
- Press the UNLOCK button on card key 2.
- From the ignition switch in the ON position, switch the ignition switch in the order indicated below.
- ACC→ON→ACC→ON→ACC→ON
- Open the driver-side front door, press the door switch twice
, and then close the door.NOTE:
- After Step 3 is completed and the card key programming mode is activated, the door lock actuator operates to lock, and then operates to unlock.
- If the door lock actuator does not operate, repeat the procedure from Step 2.
- Press the UNLOCK button on the unprogrammed card key twice. NOTE:
- After Step 8 is completed and the card key is programmed, the door lock actuator operates to lock, and then operates to unlock.
- If programming more card keys, remove the supplementary key once, and then repeat the procedure from Step 2.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
