2007 Mazda 6 MazdaspeedFACTORY OEM SERVICE PROCEDURE

Steering Angle Signal Initialization Procedure

WARNING: This page is about a different car, the 2007 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
  • If the initialization procedure of the steering angle signal is not completed, the DSC will not operate properly and may cause an accident. Therefore, always perform initialization of the DSC HU/CM steering angle signal to ensure proper DSC operation when any of the following items are performed.
    • Steering angle sensor replacement
    • DSC HU/CM replacement
  1. Inspect the wheel alignment and inflation pressure.
    • If there is any malfunction, adjust the applicable part.
  2. Park the vehicle on level ground.
  3. Turn the ignition switch off.
  4. Connect the M-MDS to the DLC-2.
  5. After the vehicle is identified, select the following items from the initial screen of the M-MDS.
    • When using the IDS (laptop PC)
      1. Select "Chassis".
      2. Select "ABS/DSC".
      3. Select "Sensor Initialization".
    • When using the PDS (Pocket PC)
      1. Select "All Tests and Calibrations".
      2. Select "Sensor Initialization".
  6. Perform the initialization procedure according to the directions on the screen.
  7. Drive the vehicle forward.
  8. After 5 min of driving, verify that the DSC system is normal.
Fig 1: Locating DLC-2 Connector
G04318417Courtesy of MAZDA MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.