2007 Mazda 6 MazdaspeedFACTORY OEM SERVICE PROCEDURE

Steering Angle Sensor Inspection

WARNING: This page is about a different car, the 2007 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the column cover. (See COLUMN COVER REMOVAL/INSTALLATION .)
  2. Measure the voltage between steering angle sensor terminal B and ground.
    • If there is any malfunction, inspect the wiring harness between steering angle sensor terminal B and battery, then repair or replace if necessary.

    Standard voltage 

    B+ 

    Fig 1: Identifying Steering Angle Sensor Connector Terminals
    G04318450Courtesy of MAZDA MOTORS CORP.
  3. Turn the ignition switch to the ON position, then measure the voltage between steering angle sensor terminal A and ground.
    • If there is any malfunction, inspect the wiring harness between steering angle sensor terminal A and ignition switch, then repair or replace if necessary.

    Standard voltage 

    B+ 

  4. Measure the voltage between steering angle sensor terminal H and the ground.
    • If there is any malfunction, inspect the wiring harness between steering angle sensor terminal H and ground point, then repair or replace if necessary.

    Standard voltage 

    0 V 

  5. Turn the ignition switch off.
  6. Connect the M-MDS to the DLC-2.
  7. Select the SWA_POS PID.
  8. Verify the SWA_POS changes when the steering wheel is turned to the left and right.
    • If there is any malfunction, replace the steering angle sensor.

    Standard 

    When the steering wheel is turned to the right: 

    SWA_POS changes positively. 

    When the steering wheel is turned to the left: 

    SWA_POS changes negatively. 

    Fig 2: Locating DLC-2 Connector
    G04318417Courtesy of MAZDA MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.