2007 Mazda 6 MazdaspeedFACTORY OEM SERVICE PROCEDURE

Combined Sensor Inspection

WARNING: This page is about a different car, the 2007 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition switch off.
  2. Connect the M-MDS to the DLC-2.
  3. Select the following PIDs, then inspect the lateral acceleration speed and the yaw rate.
    • LAT_ACCL: (lateral acceleration speed)
    • YAW_RATE: (yaw rate)
    1. Lateral acceleration speed inspection
      Fig 1: Locating DLC-2 Connector
      G04318417Courtesy of MAZDA MOTORS CORP.
      1. Verify the LAT_ACCL change when the combined sensor is tilted to the left and right.
        • If there is any malfunction, replace the combined sensor.

      Standard 

      When the sensor is tilted to the right (A): 

      LAT_ACCL changes negatively. 

      When the sensor is tilted to the left (B): 

      LAT_ACCL changes positively. 

      Fig 2: Tilting Combined Sensor Left And Right
      G04318445Courtesy of MAZDA MOTORS CORP.
    2. Yaw rate inspection
      1. Verify the YAW_RATE change when the combined sensor is rotated to the left and right.
        • If there is any malfunction, replace the combined sensor.

      Standard 

      When the sensor is rotated to the right (A): 

      YAW_RATE changes negatively. 

      When the sensor is rotated to the left (B): 

      YAW RATE changes positively. 

      Fig 3: Tilting Combined Sensor Left And Right
      G04318446Courtesy of MAZDA MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.